Recently, i bought a dual channel dash cam with 1080p front and rear cameras. I have not found out relative message about installation online, so i asked my friend for help, and the installation effect is good. Today i will share with you about installation and hope that it help the friend who need help.
1、First, Confirm the installation position of the dash cam.
A lot of novice will confirm the installation position before installing, then wiring. I also a novice, my first step is to confirm the installation position.
This is the dash cam and its holder.
Fix the dash cam on holder and tear off the sticker of the double-sided glue.
One person inside the car to determine the position and anther person outside the car to determine whether it is balance, then final location.
So it is fixed. I prefer not to block out the field of vision, so you can’t see the dash cam in the back of the interior mirror.
2、Remove the dash cam, ensure whether it works normally. If it check after wiring, so you can’t ensure whether the dash cam is the question. So before wiring, you must ensure. And then inset the memory card.
Then connect the power to the cigarette lighter and press the key to choose the language after the machine started normally.
3、The wiring of the front camera
We feel that installation is difficult, but in practice, we feel tired, but it is not very complicated.You can like this, wrap the dash cam cable down from above.
Put the cable inside the gap between the roof plant and windshield.
It is easy to put it inside with hands .
Remove the rubber form the door on the left and put the wire in, and then put the rubber back in.
The wiring is basically complete.
We directly connect the power to the fuse wire without cigarette lighter, which was to connect the wire in the box that i had grasped in my hand. I will show you how to connect.
Put all the wires in order and pull up the rubber position, the wiring will take about 10minutes.
4、Forth, connecting fuse
As mentioned just now, there are two ways to connect the dual channel dash cam , one is to directly connect to the cigarette lighter, anther method is to the fuse box. I don’t like exposed wiring, so i choose to connect to the fuse box.
Opening the cover of the fuse box, when seeing so many fuse, you will very difficult, but actually it is not complicated. Although it may vary depending on the type of car, it is generally clear which position connects and which cable is drawn after the fuse box is opened. The yellow cable is connected to a signal light, and the red one to a cigarette lighter.
The black cable is the ground wire, so just find a place near the fuse box and stick it up.
5、Wiring the rear camera
Using the dual channel, so you should install the rear camera.
As with the installing the front camera, you must confirm the location of the rear camera.
Draw the cable from the front and place it in the gap above the front door and back door.
After place the cable in the gap, you must press it to prevent falling off.
All the way to the rear of the glass is the same way to wiring, which is placed in the gap.
The rear windshield, same as front windshield, has a gap above where the cable can place in.
So the wiring of the rear camera is complete, all the wiring of the time takes about 30 minutes.
6、Turn on all the power, check whether the dash cam works normally?
Remove the SD card from the front camera, then inset the USB provided on the product box, you can connect it to the computer to see.
Connect the USB to the laptop that I had prepared, you can see the files in the SD card. Click to enter the USB file to see whether there is an accurate record file.