2017-11-17

1493

With the popularity of dash cam, almost every car installed a dash cam. For the most driver, it is a big problem to arrange the wiring. If you use open wiring, it loos low. But the driver doesn't know to use concealed wiring. Today, I will introduce the way to wiring the cable. 

The best installation location is the right side of the rear-view mirror, as far as possible close the middle, so that the shooting angle will be more positive and also more reference value.

1、According to the wiring length, arrange the best project wiring. It is recommended that you can simulate the project to make sure whether the wiring length is enough. Today we try the way following the yellow line.

3、After plug the roof line into, you need to pull down the door frame seal, and then both hands open A-pillar decoration plate fastened with a clasp, the first removal will be relatively difficult. Don't be afraid and use a little strength.  

4、The proper of removing the A-pillar is not to plug the cable into it. Some car has the side curtain airbag, in order to pass the cable smoothly, we should plug the cable into the door frame seal, finally, put the a-pill back, which is safety way.

5、From the top of A-pill down along the door frame seal, sealing strip while plug the power cable into the seal, until the bottom of the meter will be the line out.

6、Take the cable through behind the glove box.according to the car situation, you can fix the cable to the behind the glove box or hide it under the firewall or badminton glue, which is troublesome, but it looks beautiful.

7、In order to not to see a lot of open wiring around the cigarette light, we need to loosen the plate screws under the center console, open a small gap, plug the line into the gap and tighten the screws. But a lot of cars need to be flexible.

8、Plug in the cigarette light confirm that the 4k dash cam can work normally, the installation and wiring success. I spent about twenty minutes. The big problem is that you should Climb under the co-pilot pad.

Although wiring is not difficult, but complex for some new drivers. It also uses some tools. The simple way is open wiring , hang the cable in the air, but it looks low.

Editor's Recommendations：
Where to mount dash cam
How to fit a dash cam
How to install a dash cam in your car
Hidden dash cam install